Search | Statistics | User Listing | Member Roster | Coach DB Forums | Albums
FMC Owner's Forum
Home -> FMC Owner's Forum

You are logged in as a guest. ( logon | register )

#846 - Cummins Swap
Return to the album thumbnailsBack Next




Before I cut the two ends off the trans cross member (tcm) I marked R & L on them so they could be repositioned as templates to mark the original bolt-hole centers on the new angle pcs. BTW: I also measured the center to center/end to end @ 28 3/4" before I cut anything. As well, I measured the hole to hole centers across the flange from the front of coach leading edge towards the rear.


Go to FMCowners.com HomeRunning MegaBBS ASP Forum Software
© 2002-2024 PD9 Software
(Delete all cookies set by this site)